Image may be NSFW.
Clik here to view.
Are you having trouble getting your NewAir thermoelectric wine cooler to a satisfactory temperature? Follow these steps to help resolve the problem when your wine cooler won’t cool.
Please keep in mind it can take up to 48 hours for a wine cooler to reach the desired temperature after you plug it in, especially if it is filled with bottles of wine that have been stored at room temperature.
Location, Location, Location
Because of the way the technology works, thermoelectric wine coolers are not meant to be used outdoors, or in any room where the temperature reaches over 80°F. If your wine cooler is located in a garage, basement or other room without climate control, it won’t be able to lower the temperature inside the unit.
Be sure the unit is not located in direct sunlight, or next to a heat source like a stove, oven or radiator. The excess heat put out by these items will also reduce your cooler’s ability to cool effectively.
Ensure Proper Ventilation
Image may be NSFW.
Clik here to view.
Next, make sure the wine cooler has proper clearance around the side and rear air vents. We recommend at least 5 inches, to ensure adequate ventilation. If air does not circulate through the vents, excess heat will accumulate and reduce effective cooling. Eventually, the unit will burn out completely.
While you’re checking the clearance, ensure the vents are free of dust and debris, inside and out, and that the exhaust fan is working properly to dissipate heat.
A Tight Seal
Next, check the seal around the door. Is it closing properly and completely? Even small gaps can allow cold air to escape from inside. If the rubber gasket is worn or cracked, replace it so you can get a better seal. You can order a replacement gasket from customer service.
If the gasket is in good condition, it might be that the door is not hung properly. Adjusting the screws so that it hangs level can improve the overall door seal.
Is something inside the wine cooler keeping it from closing all the way? Make sure the shelves are all the way back, and that extra-tall bottles aren’t getting in the way without you realizing it. Take a moment whenever you close it to make sure it’s closed tightly. And finally, avoid opening it too often, as this can cause the interior temperature to fluctuate unnecessarily.
Electronic Malfunctions
Check the temperature control settings. Make sure you have set the thermostat to the desired temperature. Keep in mind that most of our single-zone thermoelectric wine coolers only cool down to 54°F. Dual zone coolers will chill down to 44°F. (Check your manual for the range available on your unit.)
Image may be NSFW.
Clik here to view.
Place a thermometer inside the cooler and compare the result to the temperature displayed on the control panel. If there is difference between the actual temperature and the display temperature, the problem lies with the circuit board in the unit, which will need to be replaced. Contact customer service for assistance.
What if the actual temperature matches the displayed temperature, but it still won’t reach the temperature you’ve set? If you’ve already corrected the potential problems listed above, then it’s likely that the heat pump inside the unit needs to be replaced. This is actually fairly simple to do – most handy DIYers can probably make the swap themselves in just a few minutes. Contact customer service for replacement parts, or to have a professional do the job for you.
Image may be NSFW.
Clik here to view.
If you ever have problems or questions about your wine cooler – or any NewAir product – our customer service team is just a quick phone call away. Call (855) 963-9247 to get the assistance you deserve!
The post What to Do When your Wine Cooler Won’t Cool appeared first on NewAir.com Blog.